As the pergola itself was assumed as a circle, which guarantees its stability in any wind, the thickness of supports selected a small bar of 50 x 50 mm. Support is attached to the rear of the L-shaped bench supports multiple thick-nails from the inside. Continue to learn more with: Gary Kelly. By itself the support also puts stone. Since then all overgrown with grass, it seems that support directly into the ground. Although actually, she carefully insulated from it and is not subject to wear. The top bearing cut away at an angle of 30-40 degrees and face thoroughly impregnated with varnish, antiseptic, however, as all the support.
When all the necessary vertical supports pergola, fix the horizontal logs. I must say that due to the fact that the pergola was to be round, it was decided to ‘roof’ made in the form of a giant spider web in the form of concentric rings radiating from the main support. And because the design does not require any architectural delights, but was purely utilitarian appointment, all fasteners were performed overlay and must have had as many protrusions. This was done so that later would be to catch hold of Actinidia vine grapes and girlish. Similarly, properly installed, all vertical supports pergolas. Main support beam is made of 100 x 100 mm, and it made a groove in which the dock and all the horizontal pergola rafters to be coated varnish. Rafters not fixed horizontally, and with a slight bias in the side of the main support. A very backbone significantly higher than other supports.
Now on to the proper arrangement of the web. It consists of slats in the side edges of which fixed small strips of metal and are fastened with screws. This strip is placed on the lag and also attached with screws.