aisi 201 pipe is manufactured according to technical specifications A554, American Society for Testing and Materials (ASTM) for weld pipes of high strength stainless steel. Where in mechanical engineering requires high mechanical properties or resistance to corrosion, used pipe aisi 201. aisi 201 pipe is manufactured from a strip in coils of stainless steels, using an automatic welding machine without filler metal. Pipe aisi 201 of Stainless steel is usually shipped without protective coating. If you will need special protection, the details should be defined in order. If a custom specification provides the definition of hardness, the taken one pipe aisi 201 from each of 760 m (2500 ft) from the end of which is cut off a piece for the test sample or samples from each melt stainless steel, which made the band. aisi 201 pipe shall conform requirements for tensile strength, as prescribed in Table S2.1 specifications A554 on welded pipes of high strength stainless steel.
If custom specifications include tensile test, the pipe aisi 201 must pass one test. This test should be performed on a sample taken from one pipe of each batch of 760 meters (2500 feet) to trim the ends of pipes or from a sample of each heat of stainless steel, which is made band. In accordance with the requirements of tu A554 on welded pipes of high strength stainless steel pipe aisi 201 can take various kinds of non-destructive testing. If you will require any such testing, these tests and limit values, which should be obtained as a result of these tests should be defined in order. Technical specifications A554 require the provision of information to order the pipe material. Order by material on these specifications should, as appropriate, include a position to adequately describe the desired material from which will be manufactured pipe aisi 201.